Home
应用程序分析
Fit Tolerance ISO (Ad-free)
Fit Tolerance ISO (Ad-free) Vs. Fit Tolerance Calculator

Fit Tolerance ISO (Ad-free) 对比 Fit Tolerance Calculator 的使用情况和统计数据

Limits, fits and tolerances calculator has been developed to calculate engineering tolerances of inner and outer features of journal bearings, linear bearings, thrust bearings, bushings, ball bearings, roller bearings, housings, cylinder bores, drilled holes, linear and precision shafts, pistons, etc. The calculator works in line with ISO 286-1 (2010), ISO 286-2 (2010) and ANSI B4.2 (1978) standards which are based on metric units. According to the input parameters of nominal size and hole/shaft tolerances, size limits and deviations for hole/shaft are calculated and fit type is selected among the clearance, transition and interference fits. The schematic representation of the fit is also drawn. The preferred tolerances and fits advised by ISO and ANSI standards can be found in the "Supplements" section.

Apple 应用商店
付费
公共事业

商店排名

- -

Fit Tolerance Calculator

The Fit Tolerance Calculator application calculates the fit tolerance of "hole" and "shaft" from the input diameter value. Fit tolerance is calculated based on ISO.Simply enter the diameter value, select the tolerance range with the tolerance range button, select the tolerance class with the tolerance class button, and the fitting tolerance value of "hole" and "shaft" will be displayed.In addition, from the combination of the selected hole and shaft, we distinguish the type of fit (clearance fit, transition fit, interference fit). Then, calculate the minimum clearance and the maximum clearance, in the case of clearance in plus, and in case of interference it is written minus.Input diameter of 3150 mm or less is possible. However, the number of input digits is limited to 6 digits.The corresponding tolerance range and tolerance grade are as follows.【Tolerance of hole】A, B, C, CD, D, E, EF, F, FG, G, H, JS, J, K, M, ZA, ZB, ZC* Note 1) A and B holes are not used for standard dimension 1 mm or less.* Note 2) JS 7 to JS 11 are rounded down to the decimal point so that IT / 2 becomes an integer of micrometer unit.* Note 3) The tolerance grade of J hole is IT6 to IT8 only.【Tolerance of shaft】a, b, c, cd, d, e, ef, f, fg, g, h, js, j, k, m, n, p, r, s, t, u, v, x, za, zb, zc* Note 4) The a and b shaft are not used for standard dimension 1 mm or less.* Note 5) js 7 to js 11 are rounded down to the decimal point so that IT / 2 becomes an integer of micrometer unit.* Note 6) The tolerance grade of the j shaft is IT5 to IT8 only.【Tolerance Grade】IT 1 to IT 18* Note 7) The tolerance grades IT14 to IT18 are not applied to the standard dimension of 1 mm or less.* Note 8) Tolerance values of tolerance grades IT1 to IT5 for reference dimension exceeding 500 mm are provisional for experimental use.